How to maintain the nail box machine

While paying attention to the correct use of the nail box machine, attention must be paid to the correct maintenance and maintenance of the machine. This is a key link to improve production efficiency and nail box quality and must not be ignored. Therefore, it is required to lubricate the upper head and punch of the machine once a day; the fixed shaft of the head and the fixed shaft of the left and right baffle should also be lubricated and cleaned with oil at any time; the drive shaft of the upper and lower nail heads, the grooved shaft, and the drive screw Also keep good lubrication; the lower order head is easy to accumulate in the punch due to the part of the electroplating scraps falling off when the flat wire is fed, and it should be cleaned and cleaned frequently; the order head should be disassembled for cleaning and refueling every month ; The three gears of the left and right baffles of the paper feeding belt bolt groove shaft should be filled with butter once a month; the clutch and brake should prevent oil and water from entering and infiltrating; the servo motor should be kept clean to avoid dust accumulation; the servo motor should be frequently applied Clean the heat dissipation and dust filter of the drive; the electrical control box must be kept clean to prevent dust from accumulating and causing short-circuit failure; the internal and external feeding reel shafts should be lubricated with butter to maintain reliable flexibility; requirements for power transmission gears and chains Grease grease once a month to prevent abrasion of mechanical parts.

The semi-automatic nail box machine has a low failure rate and high reliability, and maintenance is very critical. Therefore, the following tasks must be done:

1. The upper nail head punch is lubricated once a day, and the nail head is taken apart every 30 days to clean and refuel;

2. The nail heads must be cleaned frequently and the nail heads must be disassembled because the small nail wire electroplating chips fall down and accumulate in the punch;

3. Reinstall after cleaning and refueling;

4. The three gears of the left and right baffles of the paper feeding belt slot shaft, grease once every 30 days;

5. No oil or water can enter the clutch and brake;

6. The servo motor must be kept clean to avoid dust coverage, and the heat dissipation and dust filter of the servo motor drive must be cleaned frequently;

7. Keep the electrical control box clean to avoid short circuit caused by dust cover;

8. The inner and outer feeder reel should be flexible and lubricate with butter;

9. The nail head fixed shaft and the left and right baffle fixed shafts must be cleaned and lubricated with oil when moving;

10. The upper and lower nail head drive shafts, slotted shafts, and drive screws are lubricated with oil.